Mitsubishi Electric MELSEC iQ-RJ71EN71 User Manual page 241

■When a redundant system station is selected
When the networks contain a redundant system (excluding redundant line), the system status is displayed for the stations in a
redundant system.
(1)
(2)
No. Description
(1) Indicates that the station is set as a redundant system.
(2) Displays the statuses of the selected station in a redundant system (control system/standby system and system A/system B).
*1 The error of the control system CPU module may be displayed as the standby system depending on the error status.
■When the RJ71EN71 or RnENCPU is selected
When the network type of the RJ71EN71 is set to "E+CCIEF" or the network type of the RnENCPU is set to "E+IEF", status of
P1 is not displayed.
Cable Test
Cable test checks if the Ethernet cables are properly connected.
Only the Ethernet cable connected to the P1 or P2 of the target station is tested. For the whole network status, check the
network map or "Selected Station Communication Status Monitor" of the CC-Link IE Field Network diagnostics. ( Page
223 Checking the Network Status)
*1
4 TROUBLESHOOTING
4.3 Checking the Network Status
4
239