Mitsubishi Electric MELSEC iQ-RJ71EN71 User Manual page 154

Setting procedure
The procedure for the safety communication setting is shown below.
1.
Set "Communication Destination" to "Local Network".
2.
For the master station, select the target module of safety communications in "Select the target module for the Safety
Communication Setting" window and click the [Add] button.
• For a system using the SIL2 Process CPU, click the [Import Setting] button in the "Select the target module
for the Safety Communication Setting" window, and import the project of the remote head module. Only the
module set to the SIL2 mode Main of the intelligent device station (safety station) is displayed.
• In the system using the SIL2 Process CPU, set the safety connection of the master station (safety station)
and the intelligent device station (safety station) to the same setting. If the safety connection settings are
different, the safety communications may not be performed.
3.
Set the required items.
4.
Click the [OK] button to finish the safety communication setting.
2 PARAMETER SETTINGS
152
2.4 Application Settings