Mitsubishi Electric MELSEC iQ-RJ71EN71 User Manual page 283

Operation
Event code Overview
24000 Data link startup instruction
24001 Data link stop instruction
24010 Temporary error invalid station setting instruction
24011 Temporary error invalid station cancel instruction
24020 Reserved station cancel setting instruction
24021 Reserved station enable setting instruction
*1
24030 The network number, station number setting/change
instruction execution
*2
24031 Network number station number setting/change execution
24100 <<Own station>> Parameter change/new parameter
acceptance
24F00 <<Another station>> CPU operating status change
detection
*1 Only occurs in the master station.
*2 Only occurs in the local station.
Cause
Data link startup to the own station or another station was instructed.
Data link stop to the own station or another station was instructed.
Temporary error invalid station setting was instructed to the slave station.
Temporary error invalid station cancel was instructed to the slave station.
Reserved station cancel setting was instructed to the slave station.
Reserved station enable setting was instructed to the slave station.
Setting or change of the network number or station number was instructed to the
slave station.
Setting or change of the network number or station number of the own station
was executed.
Parameter was changed. Or new parameter was received at power-on.
Operating status of the programmable controller CPU on another station was
changed.
4 TROUBLESHOOTING
281
4.7 Event List
4