Warnings And Notes; Site Preparation - Alcatel-Lucent 7705 Installation Manual

Site Preparation

Warnings and Notes

Dangers:
• The 7705 SAR-F needs a disconnect device on each power feed (such as an external
circuit breaker, switch, or fuse) to disconnect DC power from the router. Disconnect both A
and B feeds before servicing.
• Do not assume that power has been disconnected from a circuit. Be sure to disconnect
power to the equipment rack and external cables before installing or removing the
7705 SAR-F.
• The 7705 SAR-F uses a fiber-optic communications method and is a Class 1 laser product.
Only trained service personnel familiar with laser radiation hazards should install or remove
fiber-optic cables and cards in this system.
Warnings:
•
•
•
•
•
Notes:
•
•
•
Page 48
To properly transport and relocate a 7705 SAR-F chassis, do the following:
→ disconnect power to the chassis by opening the disconnect devices
→ detach all cables from the router
→ if the router is installed in a rack, carefully remove it from the rack
→ repackage the router in its original shipping container for relocation
Do not install equipment that appears to be damaged.
7705 SAR-F systems should be installed in restricted access areas, such as a dedicated
equipment room or an equipment closet, in accordance with Articles 110-16, 110-17, and
110-18 of the National Electric Code ANSI/ NFPA 70.
This product complies with, and has been CE marked in accordance with, the European
Directive 99/05/EC (R&TTE) and 2004/108/EC (EMC).
Failure to comply with the equipment rack and chassis instructions as outlined in
Installation Locations on page 52
cause thermal failure.
Prepare the equipment rack and site before installing the router. Plan the router placement
near the power sources and network interface connections.
A 7705 SAR-F chassis weighs approximately 7.25 lbs (3.3 kg).
Always install the heaviest equipment on the bottom of the rack to keep the center of
gravity of the equipment rack as low as possible.
Chassis Location Requirements on page 52
and
7705 SAR-F Installation Guide
will