Configuring Radius For Service Activation And Deactivation; Configuration Example For Multiservice Activation In Access-Accept Message; Multiservice Activation Or Deactivation In Coa Message - Cisco 10000 Series Configuration Manual

Multiservice Activation or Deactivation in CoA Message

subscriber access pppoe pre-authorize nas-port-id default
subscriber authorization enable
vpdn enable
!
redirect server-group rabapol-l4redirect-group
server ip 217.89.29.149 port 80

Configuring RADIUS for Service Activation and Deactivation

Configure Cisco VSA 250 in the service profile on RADIUS to dynamically activate and deactivate
services using Access-Accept messages. This VSA has the following syntax:
250 "service(parameter1=value,parameter1=value,...)"

Configuration Example for Multiservice Activation in Access-Accept Message

To execute session rate limit static QoS services activation and parameterized QoS services, ISG should
manage multiple QoS services in one Access-Accept or CoA message as shown in the following
example:
VSA(9-1): "ip:sub-qos-policy-in=policy-in"
VSA(9-1): "ip:sub-qos-policy-out=policy-out"
VSA(9-1): "qos-policy-out=add-class(sub,(class-default),shape(2000000))"
VSA(9-1): "qos-policy-in=add-class(sub,(class-default),police(256000))"
VSA(9-250): "ARateLimitAccounting"
In the service accounting Start-Stop message, the following information is relayed:
VSA(9-1): "qos-policy-out=add-class(sub,(class-default),shape(2000000))"
VSA(9-1): "qos-policy-in=add-class(sub,(class-default),police(256000))"
VSA(9-251): "NRateLimitAccounting"
Multiservice Activation or Deactivation in CoA Message
The change of authorization (CoA) multiservice activation or deactivation message contains a list of
services. Multiple services are listed in the form of multiple lines in a VSA 252.
For the case of multiservice deactivation within one CoA message, the RADIUS server sends the request
to deactivate multiple services within one CoA multiservice deactivation message. For each service
listed in the multiservice deactivation message, the BRAS deactivates the service. Successful
deactivation of the service is followed by an Accounting-Stop message.
If a service cannot be successfully deactivated, the BRAS aborts the deactivation of all subsequent
services contained in the multiservice activation message. The BRAS activates all the services within
the same multiservice activation message that were successfully deactivated before the failed service
activated.
An existing VSA 252 is used to form one multiservice activation or deactivation CoA message. To form
one multiservice activate or deactivate CoA message, multiple lines of VSA 252 are included in the
message. The following example shows mixed multiservice activation or deactivation in one CoA
message:
RSIM Format
vsa cisco 250 S10.25.125.4
vsa cisco generic 252 binary 0b suffix " service1"
vsa cisco generic 252 binary 0b suffix " service2"
Cisco 10000 Series Router Access Network Control Protocol Configuration Guide
3-4
Chapter 3 Dynamic Multiservice Activation and Deactivation
OL-14660-03