Feature History For Configurable Connect-Info Attributes; Customizing Attribute 77 For Ethernet Connections; Customizing Attribute 77 For Atm Connections - Cisco 10000 Series Configuration Manual

Chapter 5 Dynamic Service Policy Modifications
For information about how to customize Attribute 77, see the following sections:
•
•

Feature History for Configurable Connect-Info Attributes

Cisco IOS Release
Release 12.2(31)ZV1
Release 12.2(34)SB

Customizing Attribute 77 for Ethernet Connections

To customize Attribute 77 for Ethernet connections, enter the connection information as the name of the
service policy attached to the Ethernet subinterface. The router takes the policy name and copies it to
Attribute 77.
For example, in the following configuration the outbound service policy named
speed:eth:25100:5100:19/0 is attached to the QinQ Gigabit Ethernet subinterface 1/0/0.2696. The router
copies the policy name to Attribute 77 and sends it to the RADIUS server in an Access-Request or
Accounting-Start or Stop message.
interface GigabitEthernet1/0/0.2696

Customizing Attribute 77 for ATM Connections

To customize Attribute 77 for ATM connections, configure the aaa connect-info string command in the
following configuration modes:
•
•
•
•
The router takes the name of the VC class you specify under the class-vc command or the string you
specify in the aaa connect-info string command and copies it to Attribute 77.
For example, in the following configuration the class-vc command is configured on both ATM PVCs
10/42 and 10/43 and the aaa connect-info command is configured on PVC 10/42:
interface ATM1/0/0.1 multipoint
OL-14660-03
Customizing Attribute 77 for Ethernet Connections, page 5-27
Customizing Attribute 77 for ATM Connections, page 5-27
Description
This feature was introduced on the Cisco 10000 series
router for the PRE3.
This feature was integrated into Cisco IOS
Release 12.2(34)SB and introduced on the PRE4.
encapsulation dot1q 2696 second-dot1q 256
pppoe enable group global
no snmp trap link-status
service-policy input set_precedence_to_0
service-policy output speed:eth:25100:5100:19/0
PVC (for a specific PVC)
PVC range (for a range of PVCs)
PVC-in-range (for a specific PVC in a range of PVCs)
VC class (under a specific class-vc command)
description TDSL clients - default TDSL 1024 no ip mroute-cache
class-int speed:ubr:1184:160:10
range pvc 10/41 10/160
!
Cisco 10000 Series Router Access Network Control Protocol Configuration Guide
Configurable Connect-Info Attributes
PRE Required
PRE3
PRE4
5-27