Enabling And Configuring Continuity Check For A Cfm Service - Cisco NCS 5500 Series Configuration Manual

Configuring Ethernet CFM
Command or Action

Enabling and Configuring Continuity Check for a CFM Service

To configure Continuity Check for a CFM service, complete the following steps:
SUMMARY STEPS
1. configure
2. ethernet cfm
3. domain domain-name level level-value [id [null] [dns DNS-name] [mac H.H.H] [string string] ]
4. service service-name {down-meps | xconnect group xconnect-group-name p2p xconnect-name}[id
[icc-based icc-string umc-string] | [ [number number]
5. continuity-check interval time [loss-threshold threshold]
6. continuity-check archive hold-time minutes
7. continuity-check loss auto-traceroute
8. end or commit
DETAILED STEPS
Command or Action
Step 1
configure
Example:
RP/0/RP0/CPU0:router# configure
Step 2 ethernet cfm
Example:
RP/0/RP0/CPU0:router(config)# ethernet cfm
Step 3 domain domain-name level level-value [id [null]
[dns DNS-name] [mac H.H.H] [string string] ]
Example:
RP/0/RP0/CPU0:router(config-cfm)# domain
Domain_One level 1 id string D1
Step 4
service service-name {down-meps | xconnect
group xconnect-group-name
Interface and Hardware Component Configuration Guide for Cisco NCS 5500 Series Routers, IOS XR Release
6.1.x
50
Purpose
Purpose
Enters global configuration mode.
Enters Ethernet Connectivity Fault Management (CFM) configuration
mode.
Creates and names a container for all domain configurations and enters
the CFM domain configuration mode.
The level must be specified.
The id is the maintenance domain identifier (MDID) and is used as
the first part of the maintenance association identifier (MAID) in CFM
frames. If the MDID is not specified, the domain name is used as the
MDID by default.
Configures and associates a service with the domain and enters CFM
domain service configuration mode. You can specify that the service
Configuring Ethernet OAM