Cisco 10000 Series Configuration Manual page 136

ancp adjacency timer
ancp adjacency timer
To set the interval between ANCP hello messages, use the ancp adjacency timer command in
subinterface configuration mode. To change the interval, use the no form of this command.
Syntax Description
interval
Command Default
The default is 100 ms (10 seconds).
Command Modes Subinterface
Command History Release
12.2(28)ZV
12.2(31)ZV1
Examples
The following example shows how to set the interval between ANCP hello messages from the BRAS to
the ANCP access node neighbor identified as dslam1. This example sets the interval to 200 ms.
ancp neighbor id dslam1
ancp adjacency timer 200
Related Commands Command
ancp enable
ancp neighbor
ancp atm shaper
Cisco 10000 Series Router Access Network Control Protocol Configuration Guide
A-4
ancp adjacency timer interval
no ancp adjacency timer interval
Specifies the time between ANCP hello messages to ANCP neighbors. The
interval is defined in units of 100 ms. Valid values are from 1 to 255.
Default: 100 (10 seconds).
Modification
This command was introduced and implemented on the Cisco 10000 series
router.
This command was modified for Access Network Control Protocol (ANCP),
replacing L2CP.
Description
Enables ANCP.
Specifies the ANCP access node (DSLAM) neighbor.
Enables ANCP cell tax accounting for ATM U-interface connections.
Chapter A ANCP Command Reference
OL-14660-03