Cisco 10000 Series Configuration Manual page 168

subscriber service
subscriber service
To enable per-subscriber services, use the subscriber service command in global configuration mode.
To disable service accounting, use the no form of this command.
Syntax Description coa-rfc-compliant
multiple-accept
password
police
session-accounting
shaper
target-atm-vc
Command Default
Disabled
Command Modes
Global configuration
Command History Release
Release 12.2(31)ZV1
Usage Guidelines The subscriber service session-accounting command enables the router to include all activated services
in a single accounting Session-Start message for a session.
RADIUS can activate a service using the RADIUS Access-Accept message. When RADIUS activates a
service on the router after the router sends the accounting Session-Start message, the router generates an
accounting session update that includes all activated services.
When a session stops, all currently active services are included in the accounting session stop record.
Examples The following example enables per-service accounting:
Router(config)# subscriber service session-accounting
Cisco 10000 Series Router Access Network Control Protocol Configuration Guide
A-36
subscriber service {coa-rfc-compliant | multiple-accept | password | police | session-accounting |
shaper | target-atm-vc}
no subscriber service {coa-rfc-compliant | multiple-accept | password | police | session-accounting
| shaper | target-atm-vc}
Sends RFC 3576 compliant CoA NAK messages.
Allows multiple services on access-accept.
The password to use when downloading services
QoS RADIUS service police command.
Enables the inclusion of activated services in a session accounting start
message
QoS RADIUS service shaper command.
Enables the QoS service on the target ATM VC.
Modification
This command was introduced for session-accounting and was implemented
on the Cisco 10000 series router for the PRE3.
Chapter A ANCP Command Reference
OL-14660-03