Enabling Per-Service Accounting On The Isg; Configuring Radius For Service Activation And Deactivation - Cisco 10000 Series Configuration Manual

Chapter 7 Traffic Accounting

Enabling Per-Service Accounting on the ISG

Use the following procedure to enable per-service accounting on the ISG.
SUMMARY STEPS
1.
2.
3.
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2
configure terminal
Example:
Router# configure terminal
Step 3
subscriber service session-accounting
Example:
Router(config)# subscriber service
session-accounting

Configuring RADIUS for Service Activation and Deactivation

Configure Cisco VSA 250 and VSA 252 in the service profile on RADIIUS to dynamically activate and
deactivate services. RADIUS uses VSA 250 in Access-Accept and VSA 252 in CoA messages. These
VSAs have the following syntax:
252 0b "service(parameter1=value,parameter2=value,...)"
250 "service(parameter1=value,parameter1=value,...)"
When deactivating a service, RADIUS sends the same information in VSA 252 that was used for service
activation, except that service deactivation uses 0c in the VSA instead of the 0b parameter used for
service activation. VSA 252 has the following syntax for service deactivation:
252 0xC "service(parameter1=value,parameter2=value,...)"
OL-14660-03
enable
configure terminal
subscriber service session-accounting
Cisco 10000 Series Router Access Network Control Protocol Configuration Guide
Purpose
Enables privileged EXEC mode. Enter your password if
prompted.
Enters global configuration mode.
Enables subscriber services accounting.
Per-Service Accounting
7-13