Verifying Traffic Accounting - Cisco 10000 Series Configuration Manual

Verifying Traffic Accounting

Verifying Traffic Accounting
To verify traffic accounting, use any of the following commands in privileged EXEC mode:
Command
Router# show policy-map policy-map-name
Router# show policy-map [interface interface]
[input | output] [class class-name]
Router# show policy-map session [uid uid-number]
[input | output [class class-name]]
Router# show running-config interface interface
Cisco 10000 Series Router Access Network Control Protocol Configuration Guide
7-18
dot1q 3063 second-dot1q 269 interface Gi1/1/0.30630269 client-ID "10.157.9.10/0.0.0.0
eth 2/14:7"
Purpose
Displays configuration information for the policy-map you
specify.
policy-map-name is the name of the policy-map whose
configuration you want to display.
Displays configuration information and statistics for the class
you specify. This class is included in the policy-map attached to
the interface you specify.
interface interface is the type and number of the interface.
input indicates the inbound service policy.
output indicates the outbound service policy.
class class-name is the name of the traffic class previously
configured in a class map.
Displays the QoS policy-map in effect for the PPPoE session you
specify.
(Optional) uid defines a unique session ID.
(Optional) uid-number is a unique session ID. Valid values are
from 1 to 65535.
(Optional) input displays the upstream traffic of the unique
session.
(Optional) output displays the downstream traffic of the unique
session.
(Optional) class identifies a class configured in the QoS policy
map.
(Optional) class-name is the name of the policy-map class.
Displays the configuration of the interface you specify that is
currently configured in the running-configuration file, including
any service policies attached to the interface. Also displays the
configured fixed correction factor to be applied to the
ANCP-signaled ATM line rate for the PRE2.
Chapter 7 Traffic Accounting
OL-14660-03