Cisco 10000 Series Configuration Manual page 160

show atm pvc
Table 0-2
Field
OAM Loopback
status
OAM VC state
OAM Loop
detection
ILMI VC state
VC is managed by
OAM/ILMI
InARP frequency
InPkts
OutPkts
InBytes
Cisco 10000 Series Router Access Network Control Protocol Configuration Guide
A-28
show atm pvc Field Descriptions (continued)
Description
Status of end-to-end F5 OAM loopback cell generation for this VC. This field
will have one of the following values:
OAM Disabled—End-to-end F5 OAM loopback cell generation is
•
disabled.
OAM Sent—OAM cell was sent.
•
OAM Received—OAM cell was received.
•
OAM Failed—OAM reply was not received within the frequency period or
•
contained a bad correlation tag.
This field will have one of the following states for this VC:
2 3
AIS /RDI
•
loopback cells are not sent in this state.
Down Retry—An OAM loopback failed. End-to-end F5 OAM loopback
•
cells are sent at retry frequency to verify that the VC is really down. After
down-count unsuccessful retries, the VC goes to the Not Verified state.
• Not Managed—VC is not being managed by OAM.
• Not Verified—VC has not been verified by end-to-end F5 OAM loopback
cells. AIS and RDI conditions are cleared.
• Up Retry—An OAM loopback was successful. End-to-end F5 OAM
loopback cells are sent at retry frequency to verify that the VC is really up.
After up-count successive and successful loopback retries, the VC goes to
the Verified state.
Verified—Loopbacks are successful. AIS/RDI cell was not received.
•
Status of loopback detection mode through OAM:
Disabled—Automatic loopback detection is disabled.
•
Enabled—Automatic loopback detection is enabled.
•
• Detected—Loopback mode is detected on an ATM interface.
This field will have one of the following states for this VC:
Not Managed—VC is not being managed by ILMI
•
Not Verified—VC has not been verified by ILMI.
•
Verified—VC has been verified by ILMI.
•
VC is managed by OAM or ILMI.
Number of minutes for the Inverse Address Resolution Protocol time period.
Total number of packets received on this VC. This number includes all
fast-switched and process-switched packets.
Total number of packets sent on this VC. This number includes all
fast-switched and process-switched packets.
Total number of bytes received on this VC. This number includes all
fast-switched and process-switched bytes.
—The VC received AIS/RDI cells. End-to-end F5 OAM
Chapter A ANCP Command Reference
4
.
OL-14660-03