Modifying Queue Limit; Verifying Parameterized Policies - Cisco 10000 Series Configuration Manual

Chapter 5 Dynamic Service Policy Modifications
Example: RADIUS VSA
qos-policy-out:add-class(sub,(class-default,voip),set-ip-dscp(46))

Modifying Queue Limit

ISG MQC Command
queue-limit number-of-packets
RADIUS VSA Action Parameter
queue-limit(packets-val)
Example: RADIUS VSA
qos-policy-out:add-class(sub,(class-default,voip),queue-limit(64))

Verifying Parameterized Policies

To verify the configuration of parameterized policies, use any of the following commands in privileged
EXEC mode:
Command
Router# show class-map
Router# show policy-map
Router# show policy-map interface
Router# show policy-map interface interface
[input | output]
Router# show policy-map policy-map-name
OL-14660-03
Displays
The configuration of all class-maps configured on the router.
The configuration of all policy-maps configured on the router.
The configuration of all classes configured for all policy-maps
attached to all interfaces. Also displays the service default
policy-map.
The configuration of all classes configured for all inbound or
outbound policy-maps attached to the specified interface.
interface is the name of the interface or subinterface.
input indicates to display the statistics for the attached inbound
policy.
output indicates to display the statistics for the attached outbound
policy.
Note If you do not specify input or output, the router shows
information about all classes that are configured for all
inbound and outbound policies attached to the interface
you specify.
The configuration of all classes contained in the policy-map you
specify.
policy-map-name is the name of the policy-map for the
configuration information you want to display.
If you do not specify a policy-map-name, the command displays
the configuration of all policy-maps configured on the router.
Cisco 10000 Series Router Access Network Control Protocol Configuration Guide
Verifying Parameterized Policies
5-25