Feature History For Multiservice Activation In Access-Accept Message; Qos Policy For Vsa 250 - Cisco 10000 Series Configuration Manual

Multiservice Activation in an Access-Accept Message
The RSIM format for Access-Accept multiple services requests for QoS services is not applicable for
Note
multiple service activation or deactivation requests in a CoA message. The format for CoA messages is
VSA 252; for more information, refer to the
section on page
The following sections provide more information about multiservice activation in Access-Accept
messages:
•
•
•
•

Feature History for Multiservice Activation in Access-Accept Message

Release
Release 12.2(31)ZV
Release 12.2(31)ZV1 and
12.2(31)ZV2
Release 12.2(34)SB

QoS Policy for VSA 250

ISG manages multiple QoS services in one Access-Accept message and applies the message to activate
static and parameterized QoS. The concatenated qos:vc-qos-policy-out syntax is used with the RADIUS
Access-Accept message while establishing a session. The ISG parses the VSA 250 concatenated string
and activates or deactivates the ISG service and the QoS policies as shown in the following example:
qos:<qos-attribute-name>=<attribute value>[;qos:<qos-attribute-name>=<attribute value>...]
qos-attribute-name displays the QoS attribute name. The accepted attributes for the qos-attribute-name
in this special concatenated format are:
•
•
•
•
•
attribute-value displays the value to be assigned to the QoS attribute. The platform determines the
acceptable range of values.
If the target session is an ATM VC, the ISG interprets the VC weight (vc-weight), the minimum VC
watermark (vc-watermark-min), and the maximum VC watermark (vc-watermark-max) attributes.
The following example shows the concatenated QoS syntax for VSA 250:
Cisco 10000 Series Router Access Network Control Protocol Configuration Guide
3-2
3-4.
Feature History for Multiservice Activation in Access-Accept Message, page 3-2
QoS Policy for VSA 250, page 3-2
Configuring Multiservice Activation Using Access-Accept Messages, page 3-3
Configuration Example for Multiservice Activation in Access-Accept Message, page 3-4
Modification
This feature was introduced on the Cisco 10000 series
router for the PRE2.
This feature was introduced on the PRE3.
This feature was integrated into Cisco IOS
Release 12.2(34)SB and introduced on the PRE4.
vc-qos-policy-in
vc-qos-policy-out
vc-weight
vc-watermark-min
vc-watermark-max
Chapter 3 Dynamic Multiservice Activation and Deactivation
"Multiservice Activation or Deactivation in CoA Message"
PRE
PRE2
PRE3
PRE4
OL-14660-03