Feature History For Ancp Corrected Rate; Configuring The Ancp Corrected Rate - Cisco 10000 Series Configuration Manual

ANCP Corrected Rate
Ethernet/DSL
"Access-Node-Identifier ethernet slot/port[:vlan-id]"
The BRAS uses the fixed correction factor you specify for ATM or Ethernet overhead to calculate the
correct line rate. It then sends the modified rate to the RADIUS server in an Access-Request and
Accounting-Start message. RADIUS uses the information in the message and in the appropriate
RADIUS profile to determine the actual session rate. RADIUS signals the corrected rate in an
Access-Accept message.
The BRAS uses the corrected rate from RADIUS to determine the shaping and policing rate for the
session. The BRAS updates the local QoS policy-map and applies the corrected line rate to the
subinterface that terminates the link.

Feature History for ANCP Corrected Rate

Cisco IOS Release
Release 12.2(28)ZV
Release 12.2(31)ZV1

Configuring the ANCP Corrected Rate

Use the following procedure to configure the fixed correction factor for a BRAS with a PRE2.
SUMMARY STEPS
1.
2.
3.
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2
configure terminal
Example:
Router# configure terminal
Cisco 10000 Series Router Access Network Control Protocol Configuration Guide
7-16
Description
This feature was introduced on the Cisco 10000 series
router and was applied globally.
This feature was enhanced to apply to subinterfaces.
enable
configure terminal
ancp atm shaper percent-factor factor
or
ancp vdsl ethernet shaper percent-factor factor
Purpose
Enables privileged EXEC mode. Enter your password if
prompted.
Enters global configuration mode.
Chapter 7 Traffic Accounting
PRE Required
PRE2
PRE2
OL-14660-03