Danfoss VLT AQUA FC 200 Series Programming Manual page 8

1 How to Programme
[Hand On]
enables control of the frequency converter via the GLCP. [Hand on] also starts the motor, and it is now possible to give the motor speed reference by
1
means of the arrow keys. The key can be
The following control signals will still be active when [Hand on] is activated:
• [Hand on] - [Off] - [Auto on]
• Reset
• Coasting stop inverse (motor coasting to stop)
• Reversing
• Set-up select lsb - Set-up select msb
• Stop command from serial communication
• Quick stop
• DC brake
NB!
External stop signals activated by means of control signals or a serial bus will override a "start" command via the LCP.
[Off]
stops the connected motor. The key can be
[Off] key is inactive the motor can only be stopped by disconnecting the mains supply.
[Auto On]
enables the frequency converter to be controlled via the control terminals and/or serial communication. When a start signal is applied on the control
terminals and/or the bus, the frequency converter will start. The key can be
NB!
An active HAND-OFF-AUTO signal via the digital inputs has higher priority than the control keys [Hand on] – [Auto on].
[Reset]
is used for resetting the frequency converter after an alarm (trip). The key can be
The parameter shortcut
can be carried out by holding down the [Main Menu] key for 3 seconds. The parameter shortcut allows direct access to any parameter.
1.1.2 Quick Transfer of Parameter Settings between Multiple Frequency Converters
Once the set-up of a frequency converter is complete, we recommend
that you store the data in the LCP or on a PC via MCT 10 Set-up Software
Tool.
8
Enabled [1] or Disabled [0] via par. 0-40 [Hand on] Key on LCP.
Enabled Disabled
[1] or [0] via par.
Enabled
®
MG.20.O4.02 - VLT
®
VLT AQUA Drive Programming Guide
0-41 [Off] key on LCP.
If no external stop function is selected and the
Disabled 0-42 [Auto on] key on LCP.
[1] or [0] via par.
Enabled [1] or Disabled [0] via par. 0-43
is a registered Danfoss trademark
Reset Keys on LCP .