Danfoss VLT AQUA FC 200 Series Programming Manual page 100

2 Parameter Description
8-40 Telegram Selection
Option:
[1] * Standard telegram 1
2
[101] PPO 1
[102] PPO 2
[103] PPO 3
[104] PPO 4
[105] PPO 5
[106] PPO 6
[107] PPO 7
[108] PPO 8
[200] Custom telegram 1
2.9.5 8-5* Digital/Bus
Parameters for configuring the control word Digital/Bus merging.
8-50 Coasting Select
Option:
[0] Digital input
[1] Bus
[2] Logic AND
[3] * Logic OR
NB!
This parameter is active only when par.8-01
8-52 DC Brake Select
Option:
[0] Digital input
[1] Bus
[2] Logic AND
[3] * Logic OR
NB!
This parameter is active only when par.8-01
100
Function:
Enables use of freely configurable telegrams or standard telegrams for the FC port.
Function:
Select control of the coasting function via the terminals (digital input) and/or via the bus.
Activates Start command via the serial communication port or fieldbus option.
Activates Start command via the fieldbus/serial communication port, AND additionally via one of the
digital inputs.
Activates Start command via the fieldbus/serial communication port OR via one of the digital inputs.
Control Site is set to [0] Digital and control word
Function:
Select control of the DC brake via the terminals (digital input) and/or via the fieldbus.
Activates Start command via the serial communication port or fieldbus option.
Activates Start command via the fieldbus/serial communication port, AND additionally via one of the
digital inputs.
Activates Start command via the fieldbus/serial communication port OR via one of the digital inputs.
Control Site Digital and control word
is set to [0]
®
MG.20.O4.02 - VLT is a registered Danfoss trademark
®
VLT AQUA Drive Programming Guide
.
.