Danfoss VLT AQUA FC 200 Series Programming Manual page 18

1 How to Programme
NB!
1
Resets parameters selected in Personal Menu with default factory setting.
par.14-22 Operation Mode
RFI Filter
par. 14-50
par. 8-30 Protocol
Address
par.8-31
Baud Rate
par.8-32
par.8-35 Minimum Response Delay
Maximum Response Delay
par.8-36
par.8-37 Maximum Inter-Char Delay
Operating Hours
par.15-00
Historic Log: Event
par.15-20
par.15-30 Alarm Log: Error Code
Manual initialisation
1. Disconnect from mains and wait until the display turns off.
2a. Press [Status] - [Main Menu] - [OK] at the same time while power up for LCP 102, Graphical Display
2b. Press [Menu] while power up for LCP 101, Numerical Display
3. Release the keys after 5 s.
4. The frequency converter is now programmed according to default settings.
This procedure initializes all except: par.15-00
NB!
When you carry out manual initialisation, you also reset serial communication, par. 14-50
Removes parameters selected in par.25-00
NB!
After initialization and power cycling, the display will not show any information until after a couple of minutes.
18
initialises all except:
Over Volt's
to par.15-05
Historic Log: Time
to par.15-22
to par.15-32 Alarm Log: Time
Operating Hours
; par.15-03
Cascade Controller
MG.20.O4.02 - VLT
®
VLT
Power Up's Over Temp's
; par.15-04 ; par.15-05
RFI Filter
.
®
is a registered Danfoss trademark
AQUA Drive Programming Guide
Over Volt's
.
and fault log settings.