Danfoss VLT AQUA FC 200 Series Programming Manual page 144

2 Parameter Description
15-07 Reset Running Hours Counter
Option:
[0] * Do not reset
[1] Reset counter
2
15-08 Number of Starts
Range:
0 N/A* [0 - 2147483647 N/A]
NB!
This parameter will be reset when resetting par.15-07
2.14.3 15-1* Data Log Settings
The Data Log enables continuous logging of up to 4 data sources (par. 15-10
event (par.15-12 Trigger Event
15-10 Logging Source
Array [4]
None
[1600] Control Word
[1601] Reference [Unit]
[1602] Reference %
[1603] Status Word
[1610] Power [kW]
[1611] Power [hp]
[1612] Motor Voltage
[1613] Frequency
[1614] Motor Current
[1616] Torque [Nm]
[1617] Speed [RPM]
[1618] Thermal Motor Load
[1622] Torque [%]
[1630] DC Link Voltage
[1632] Brake Energy / s
[1633] Brake Energy / 2 min
[1634] Heatsink Temp.
[1635] Thermal Drive Load
[1650] External Reference
[1652] Feedback [Unit]
[1654] Feedback 1 [Unit]
[1655] Feedback 2 [Unit]
144
Function:
Do not reset
Select
Reset counter
Select
Hours
) and par.15-08
Function:
This is a read out parameter only. The counter shows the numbers of starts and stops caused by a
normal Start/Stop command and/or when entering/leaving sleep mode.
) and window (par.15-14 Samples Before Trigger
Select which variables are to be logged.
MG.20.O4.02 - VLT
VLT
[0] if no reset of the Running Hours counter is desired.
[1] and press [OK] to reset the Running Hours counter (par.15-01
Number of Starts
to zero (see also par.15-01
Reset Running Hours Counter
.
Logging Source ) at individual rates (par.15-11
) are used to start and stop the logging conditionally.
®
is a registered Danfoss trademark
®
AQUA Drive Programming Guide
Running
Running Hours
).
Logging Interval ). A trigger