Danfoss VLT AQUA FC 200 Series Programming Manual page 17

®
VLT AQUA Drive Programming Guide
1.1.13 Changing a Group of Numeric Data Values
If the chosen parameter represents a numeric data value, change the
chosen data value by means of the [◄] and [►] navigation keys as well
▲ ▼
] navigation keys. Use the ◄] and [►] navigation
as the up/down [ ] [
keys to move the cursor horizontally.
Use the up/down navigation keys to change the data value. The up key
enlarges the data value, and the down key reduces the data value. Place
the cursor on the value to be saved and press [OK].
1.1.14 Changing of Data Value, Step-by-Step
Certain parameters can be changed step by step or infinitely variably. This applies to par.1-20
Motor Frequency
1-23 .
The parameters are changed both as a group of numeric data values and as numeric data values infinitely variably.
1.1.15 Read-out and Programming of Indexed Parameters
Parameters are indexed when placed in a rolling stack.
Alarm Log: Error Code
par.15-30 to par.15-32
up/down navigation keys to scroll through the value log.
Preset Reference
Use par.3-10 as another example:
Choose the parameter, press [OK], and use the up/down navigation keys keys to scroll through the indexed values. To change the parameter value,
select the indexed value and press [OK]. Change the value by using the up/down keys. Press [OK] to accept the new setting. Press [Cancel] to abort.
Press [Back] to leave the parameter.
1.1.16 Initialisation to Default Settings
Initialise the frequency converter to default settings in two ways:
Recommended initialisation (via par.14-22
1. Select par.14-22 Operation Mode
2. Press [OK]
3. Select "Initialisation"
4. Press [OK]
Alarm Log: Time
contain a fault log which can be read out. Choose a parameter, press [OK], and use the
Operation Mode
)
5.
6.
7.
®
MG.20.O4.02 - VLT is a registered Danfoss trademark
Illustration 1.17: Display example.
Illustration 1.18: Display example.
Motor Power [kW]
, par. 1-22
Cut off the mains supply and wait until the display turns off.
Reconnect the mains supply - the frequency converter is now
reset.
Operation Mode
Change par.14-22
1 How to Programme
1
Motor Voltage
and par.
Normal Operation
back to .
17