Danfoss VLT AQUA FC 200 Series Programming Manual page 118

Hide thumbs Also See for VLT AQUA FC 200 Series:
Table of Contents

Advertisement

2 Parameter Description
10-31 Store Data Values
Option:
2
[0] *
Off
[1]
Store all setups
[2]
Store all setups
10-32 Devicenet Revision
Range:
0 N/A*
[0 - 65535 N/A]
10-33 Store Always
Option:
[0] *
Off
[1]
On
10-39 Devicenet F Parameters
Array [1000]
No LCP access
Range:
0 N/A*
[0 - 0 N/A]
118
Function:
Parameter values changed via DeviceNet are not automatically stored in non-volatile memory. Use
this parameter to activate a function that stores parameter values in the EEPROM non-volatile
memory, so changed parameter values will be retained at power-down.
Deactivates the non-volatile storage function.
Stores all parameter values from the active set-up in the non-volatile memory. The selection returns
to Off [0] when all values have been stored.
Stores all parameter values for all set-ups in the non-volatile memory. The selection returns to
Off
[0] when all parameter values have been stored.
Function:
View the DeviceNet revision number. This parameter is used for EDS file creation.
Function:
Deactivates non-volatile storage of data.
Stores parameter data received via DeviceNet in EEPROM non-volatile memory as default.
Function:
This parameter is used to configure the frequency converter via DeviceNet and build the EDS-file.
®
MG.20.O4.02 - VLT
is a registered Danfoss trademark
®
VLT
AQUA Drive Programming Guide

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the VLT AQUA FC 200 Series and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents