I-1-1-2 For Vigor2860Ac / Vigor2860N-Plus / Vigor2860N/Vigor2860Ln - Draytek Vigor2860 User Manual

I - 1 - 1 - 2 F o
I - 1 - 1 - 2 F o
LED
ACT (Activity)
WAN2
QoS
USB
LTE
DSL
WCF
2.4G/5G/WLAN
Vigor2860 Series User's Guide
r V i g o r 2 8 6 0 a c / V i g
r V i g o r 2 8 6 0 a c / V i g
Status
Blinking
Off
On
Off
Blinking
On
On
Blinking
On
Off
Blinking
On
Blinking
On
On
Blinking
o r 2 8 6 0 n - p l u s / V i g o
o r 2 8 6 0 n - p l u s / V i g o
Explanation
The router is powered on and running normally.
The router is powered off.
Internet connection is ready.
Internet connection is not ready.
The data is transmitting.
The QoS function is active.
USB device is connected and ready for use.
The data is transmitting.
LTE device is connected and ready for use.
LTE device is not detected, or has serious problem
(e.g., no SIM card, SIM pin error, SIM deactivated, and
etc.).
Slowly: LTE device is in dialing up.
Quickly: The data is transmitting.
The router is ready to access Internet through DSL link.
Slowly: The DSL connection is ready.
Quickly: The connection is training.
The Web Content Filter is active. (It is enabled from
Firewall >> General Setup).
2.4G/5G: Wireless access point with bandwidth of
2.4GHz/5GHz is ready.
WLAN: Wireless access point is ready.
It will blink slowly while wireless traffic goes through.
ACT and WLAN LEDs blink quickly and simultaneously
when WPS is working, and will return to normal
condition after two minutes. (You need to setup WPS
r 2 8 6 0 n / V i g o r 2 8 6 0 L
r 2 8 6 0 n / V i g o r 2 8 6 0 L
n
n
5