Draytek Vigor2860 User Manual page 772

T e l n e t C o m m
T e l n e t C o m m
This command allows users to set static route.
S S y y n n t t a a x x
ip route add [dst] [netmask][gateway][ifno][rtype]
ip route del [dst] [netmask][rtype]
ip route status
ip route cnc
ip route default [wan1/wan2/off/?]
ip route clean [1/0]
S y n t a x
S y n t a x
Parameter
add
del
status
dst
netmask
gateway
ifno
rtype
cnc
default
clean
E x a m p l
E x a m p
> ip route add 172.16.2.0 255.255.255.0 172.16.2.4 3 static
> ip route status
Codes: C - connected, S - static, R - RIP, * - default, ~ - private
C~
S
758
a n d : i p r o u t e
a n d : i p r o u t e
D e s c r i p t i o n
D e s c r i p t i o n
Description
It means to add an IP address as static route.
It means to delete specified IP address.
It means current status of static route.
It means the IP address of the destination.
It means the netmask of the specified IP address.
It means the gateway of the connected router.
It means the connection interface.
3=WAN1 5=WAN3,6=WAN4,7=WAN5
However,
WAN3, WAN4, WAN5 are router-borne WANs
It means the type of the route.
default : default route;
static: static route.
It means current IP range for CNC Network.
Set WAN1/WAN2/off as current default route.
Clean all of the route settings.
1: Enable the function.
0: Disable the function.
e
l e
192.168.1.0/
172.16.2.0/
255.255.255.0 is directly connected, LAN1
255.255.255.0 via 172.16.2.4, WAN1
Vigor2860 Series User's Guide