For Vigor2860N-Plus - Draytek Vigor2860 series Quick Start Manual

1 . 1 . 3 F o r V i g
1 . 1 . 3 F o r V i g
LED
ACT (Activity)
USB
2.4G
WAN2
DSL
5G
QoS
WCF
Vigor2860 Series Quick Start Guide
o r 2 8 6 0 n - p l u s
o r 2 8 6 0 n - p l u s
Status Explanation
Blinking The router is powered on and running
normally.
Off The router is powered off.
On USB device is connected and ready for use.
Blinking The data is transmitting.
On
Wireless access point with transmission
rate of 2.4G is ready.
Blinking
It will blink slowly while wireless traffic
goes through.
ACT and WLAN LEDs blink quickly and
simultaneously when WPS is working, and
will return to normal condition after two
minutes. (You need to setup WPS within 2
minutes.)
On Internet connection is ready.
Off Internet connection is not ready.
Blinking The data is transmitting.
On The router is ready to access Internet
through DSL link.
Blinking Slowly: The DSL connection is ready.
Quickly: The connection is training.
On
Wireless access point with transmission
rate of 5G is ready.
Blinking
It will blink slowly while wireless traffic
goes through.
ACT and WLAN LEDs blink quickly and
simultaneously when WPS is working, and
will return to normal condition after two
minutes. (You need to setup WPS within 2
minutes.)
On The QoS function is active.
On The Web Content Filter is active. (It is
enabled from Firewall >> General
Setup).
6