Draytek Vigor2860 User Manual page 651

To set a new profile, please do the steps listed below:
1. Click the number (e.g., #1) under Index column for configuration in details.
2. The configuration page will be shown as follows:
Available settings are explained as follows:
Item
Name
Address Type
Mac Address
Start IP Address
End IP Address
Prefix Length
Invert Selection
3. After finishing all the settings, please click OK to save the configuration.
Vigor2860 Series User's Guide
Description
Type a name for this profile. Maximum 15 characters are
allowed.
Determine the address type for the IPv6 address.
Select Single Address if this object contains one IPv6 address
only.
Select Range Address if this object contains several IPv6s
within a range.
Select Subnet Address if this object contains one subnet for
IPv6 address.
Select Any Address if this object contains any IPv6 address.
Select Mac Address if this object contains Mac address.
Type the MAC address of the network card which will be
controlled.
Type the start IP address for Single Address type.
Type the end IP address if the Range Address type is
selected.
Type the number (e.g., 64) for the prefix length of IPv6
address.
If it is checked, all the IPv6 addresses except the ones listed
above will be applied later while it is chosen.
637