Draytek Vigor2860 User Manual page 806

mngt accesslist add [index][ip addr][mask]
mngt accesslist remove [index]
mngt accesslist flush
S S y y n n t t a a x x
Parameter
list
add
index
ip addr
mask
remove
flush
E x a m p l
E x a m p
> mngt accesslist add 1 192.168.1.89 255.255.255.0
%% Set OK.
> mngt accesslist list
%% Access list :
Index IP address
==========================================
1
T e l n e t C o m m
T e l n e t C o m m
This command allows you to configure SNMP for management.
S y n t a x
S y n t a x
mngt snmp [-<command> <parameter> | ... ]
S y n t a x
S y n t a x
Parameter
[<command>
<parameter>|...]
-e <1/2>
-g<Community name>
-s <Community name>
-m <IP address>
-t <Community name>
-n <IP address>
-T <seconds>
792
D D e e s s c c r r i i p p t t i i o o n n
Description
It can display current setting for your reference.
It means adding a new entry.
It means to specify the number of the entry.
It means to specify an IP address.
It means to specify the subnet mask for the IP address.
It means to delete the selected item.
It means to remove all the settings in the access list.
e
l e
192.168.1.89
a n d : m n g t s n m p
a n d : m n g t s n m p
D e s c r i p t i o n
D e s c r i p t i o n
Description
The available commands with parameters are listed below.
[...] means that you can type in several commands in one line.
1: Enable the SNMP function.
2: Disable the SNMP function.
It means to set the name for getting community by typing a proper
character. (max. 23 characters)
It means to set community by typing a proper name. (max. 23
characters)
It means to set one host as the manager to execute SNMP function.
Please type in IPv4 address to specify certain host.
It means to set trap community by typing a proper name. (max. 23
characters)
It means to set the IPv4 address of the host that will receive the
trap community.
It means to set the trap timeout <0~999>.
Subnet mask
255.255.255.0
Vigor2860 Series User's Guide