Ii-4-5 Radius/Tacacs; Ii-4-5-1 External Radius - Draytek Vigor2860 User Manual

I I - 4 - 5 R A
I I - 4 - 5 R A
Remote Authentication Dial-In User Service (RADIUS) is a security authentication
client/server protocol that supports authentication, authorization and accounting, which is
widely used by Internet service providers. It is the most common method of authenticating
and authorizing dial-up and tunneled network users.
I I - 4 - 5 - 1 E
I I - 4 - 5 - 1 E
The built-in RADIUS client feature enables the router to assist the remote dial-in user or a
wireless station and the RADIUS server in performing mutual authentication. It enables
centralized remote access authentication for network management.
Vigor router can be operated as a RADIUS client. Therefore, this page is used to configure
settings for external RADIUS server. Then LAN user of Vigor router will be authenticated by
such server for network application.
Available settings are explained as follows:
Item
Enable
Server IP Address
Destination Port
Shared Secret
Confirm Shared Secret
After finished the above settings, click OK button to save the settings.
Vigor2860 Series User's Guide
D I U S / T A C A C S +
D I U S / T A C A C S +
x t e r n a l R A D I U S
x t e r n a l R A D I U S
Description
Check to enable RADIUS client feature.
Enter the IP address of RADIUS server
The UDP port number that the RADIUS server is using. The
default value is 1812, based on RFC 2138.
The RADIUS server and client share a secret that is used to
authenticate the messages sent between them. Both sides
must be configured to use the same shared secret. The
maximum length of the shared secret you can set is 36
characters.
Re-type the Shared Secret for confirmation.
195