Draytek Vigor2860 User Manual page 926

10.Traffic limit unit (download) : 1
flag : 49
T e l n e t C o m m
T e l n e t C o m m
This command is used to enable/disable AP detection function.
S S y y n n t t a a x x
apm napdetect [get]
apm napdetect [set] [enable/disable AP Detection 1/0][Refresh Time].
S y n t a x
S y n t a x
Parameter
get
set
enable/disable AP Detection
1/0
Refresh Time
E E x x a a m m p p l
Note: To check the scanning result of AP detection, use the command of "wl scan show".
> apm napdetect set 1 1
> wl scan show 3
Sta Ch SSID
Period First Detected Last Detected
11 DrayTek-LAN-B
11 DrayTek-LAN-A
Dec 09,10:35:44 Dec 09,10:35:44
T e l n e t C o m m
T e l n e t C o m m
This command is used to display the AP syslog data coming form VigorAP.
S y n t a x
S y n t a x
apm apsyslog [AP_Index]
S y n t a x
S y n t a x
Parameter
AP_Index
E x a m p l
E x a m p
> apm apsyslog 1
8d 02:46:09 syslog: [APM] Send Rogue AP Detection data.
8d 02:53:04 syslog: [APM] Run AP Detection / Discovery.
8d 02:56:09 syslog: [APM] Send Rogue AP Detection data.
8d 03:00:42 kernel: 60:fa:cd:55:f5:ea had disassociated.
8d 03:03:12 syslog: [APM] Run AP Detection / Discovery.
8d 03:06:09 syslog: [APM] Send Rogue AP Detection data.
912
a n d : a p m n a p d e t
a n d : a p m n a p d e t
D e s c r i p t i o n
D e s c r i p t i o n
Description
It is used to get AP detection data from VigorAP (e.g., AP900).
It allows to set detect configuration to VigorAP.
It is used to enable or disable the AP detection function.
0 – disable the function.
1 – enable the function.
Available values are 1, 3 or 5 (minutes).
l e e
BSSID
02:1d:aa:4c:bd:a8
00:1d:aa:4f:bd:a8
a n d : a p m a p s y s l o
a n d : a p m a p s y s l o
D e s c r i p t i o n
D e s c r i p t i o n
Description
Specify the index number which represents VigorAP.
e
l e
e c t
e c t
BssType Security Siganl(%) Beacon
AP
AP
g
g
Mixed 26 100
Mixed 42 100
Vigor2860 Series User's Guide