Ii-4-12-1 General Setup - Draytek Vigor2860 User Manual

I I - 4 - 1 2 - 1
I I - 4 - 1 2 - 1
Available settings are explained as follows:
Item
Group ID
Priority ID
Authentication Key
Protocol
212
Such method is suitable for a user which has multiple ISP
accounts. With such method;



G e n e r a l S e t u p
G e n e r a l S e t u p
Description
Type a value (1~255).
In LAN environment, multiple routers can be devided into
several groups. Each router must be specified with one group
ID. Different routers with the same ID value will be
categoried into the same group.
Only one of the routers in the same group will be selected as
the primary router.
Type a value (1~30).
Different routers must be configured with different IDs.
The router with the highest priority will be treated as
primary router. If multiple routers have the same priority,
the router with lower "IP" will be treated as primary. "IP" is
the IP address configured on LAN >> General Setup page, in
which LAN is determined by management interface.
Type a string as the authentication key (maximum 31
characters allowed).
It is used for encrypting the DARP to prevent malicious
attack.
Choose IPv4 or IPv6.
All WANs of secondary routers can be up. Therefore,
the user can route its traffic to secondary.
WAN settings of primary and secondary routers must
not be the same.
The Config Sync must be disabled, or you cannot change
redundancy method to active-standby.
Vigor2860 Series User's Guide