Draytek Vigor2860 User Manual page 762

TIMEOUT
-a
-e
ATTACK_0
-d
E x a m p l
E x a m p
>dos –A
The Dos Defense system is Activated
>dos –s synflood 50 10
Synflood is enabled! Threshold=50 <pke/sec> timeout=10 <pke/sec>
T e l n e t C o m m
T e l n e t C o m m
Type this command will leave telnet window.
T e l n e t C o m m
T e l n e t C o m m
This command allows you to configure detailed settings for WAN connection.
S S y y n n t t a a x x
internet -W n -M n [-<command> <parameter> | ... ]
S y n t a x
S y n t a x
Parameter
-M n
<command><parameter>|...]
-S <isp name>
-P <on/off>
-u <username>
-p <password>
-a n
-t n
748
It means the time (seconds) that a flooding attack will be blocked.
Set a value larger than 5.
It means to enable the defense function for all attacks listed in
ATTACK_0.
It means to enable defense function for a specific attack(s).
It means to specify a name of the following attacks: ip_option,
tcp_flag, land, teardrop, smurf, pingofdeath, traceroute,
icmp_frag, syn_frag, unknow_proto, fraggle.
It means to disable the defense function for a specific attack(s).
e
l e
a n d : e x i t
a n d : e x i t
a n d : I n t e r n e t
a n d : I n t e r n e t
D e s c r i p t i o n
D e s c r i p t i o n
Description
M means to set Internet Access Mode (Mandatory) and n means
different modes (represented by 0 – 3)
n=0: Offline
n=1: PPPoE
n=2: Dynamic IP
n=3: Static IP
The available commands with parameters are listed below.
[...] means that you can type in several commands in one line.
It means to set ISP Name (max. 23 characters).
It means to enable PPPoE Service.
It means to set username (max. 49 characters) for Internet
accessing.
It means to set password (max. 49 characters) for Internet
accessing.
It means to set PPP Authentication Type and n means different
types (represented by 0-1).
n=0: PAP/CHAP (this is default setting)
n=1: PAP Only
It means to set connection duration and n means different
conditions.
Vigor2860 Series User's Guide