I-1-1 Indicators And Connectors; I-1-1-1 For Vigor2860 / Vigor2860L - Draytek Vigor2860 User Manual

I - 1 - 1 I n d
I - 1 - 1 I n d
Before you use the Vigor router, please get acquainted with the LED indicators and
connectors first.
I - 1 - 1 - 1 F o
I - 1 - 1 - 1 F o
LED
ACT (Activity)
WAN2
QoS
USB1~2 / USB
LTE
DSL
WCF
VPN
DoS
LED on Connector
WAN2
(Giga)
GigaL
2
i c a t o r s a n d C o n n
i c a t o r s a n d C o n n
r V i g o r 2 8 6 0 / V i g o r
r V i g o r 2 8 6 0 / V i g o r
Status
Blinking
Off
On
Off
Blinking
On
On
Blinking
On
Off
Blinking
On
Blinking
On
On
Off
Blinking
On
Blinking
Left On
LED
Off
Blinking
Right On
LED
Off
Left On
LED
Off
e c t o r s
e c t o r s
2 8 6 0 L
2 8 6 0 L
Explanation
The router is powered on and running normally.
The router is powered off.
Internet connection is ready.
Internet connection is not ready.
The data is transmitting.
The QoS function is active.
USB device is connected and ready for use.
The data is transmitting.
LTE device is connected and ready for use.
LTE device is not detected, or has serious problem
(e.g., no SIM card, SIM pin error, SIM deactivated, and
etc.).
Slowly: LTE device is in dialing up.
Quickly: The data is transmitting.
The router is ready to access Internet through DSL link.
Slowly: The DSL connection is ready.
Quickly: The connection is training.
The Web Content Filter is active. (It is enabled from
Firewall >> General Setup).
The VPN tunnel is active.
VPN services are disabled
Traffic is passing through VPN tunnel.
The DoS function is active.
It will blink while detecting an attack.
The port is connected.
The port is disconnected.
The data is transmitting.
The port is connected with 1000Mbps.
The port is connected with 10/100Mbps
The port is connected.
The port is disconnected.
Vigor2860 Series User's Guide