Table 2-25 Control Interface (Outputs) - Siemens SIMATIC ET 200S Operating Instructions Manual

1Count24V/100kHz
2.8 Position Detection
Address Assignment
Byte 6 Bit 7:
Bit 6:
Bit 5:
Bit 4:
Bit 3:
Bit 2:
Bit 1:
Bit 0:
Byte 7 Reserve = 0
Bytes 8 to 11 Count value
Modified user data interface
1
Table 2-25 Control Interface (Outputs)
Address
Bytes 0 to 3
Byte 0
Bytes 1 to 3
Byte 4 EXTF_ACK
RES_STS
CTRL_SYN
SW_GATE
98
Zero crossing
Low counting limit
High counting limit
Reserve = 0
Reserve = 0
Reserve = 0
Reserve = 0
Synchronization status
1
Assignment
Load value direct, preparatory, comparison value 1 or 2
Behavior of DO1, DO2 of the 1Count24V/100kHz
Bit 2 Bit 1
0 0
0 0
0 1
0 1
1 0
1 0
1 1
1 1
Bit 5
0
0
1
1
Bits 3, 6, and 7: Reserve = 0
Byte 1: Hysteresis DO1, DO2 (range 0 to 255)
Byte 2: Pulse duration [2ms] DO1, DO2 (range 0 to 255)
Byte 3: Reserve = 0
Bit 7: Error diagnostics acknowledgment
Bit 6: Reserve = 0
Bit 5: Reserve = 0
Bit 4: Reserve = 0
Bit 3: Reserve = 0
Bit 2: Start resetting of status bit
Bit 1: Enable synchronization
Bit 0: SW gate control bit
Bit 0 Function DO1
0 Output
1 Switch on at count ≥ comparison value
0 Switch on at count ≤ comparison value
1 Pulse on reaching the comparison value
0 Switch at comparison values
1 blocked
0 blocked
1 blocked
Bit 4 Function DO2
0 Output
1 Switch on at count ≥ comparison value
0 Switch on at count ≤ comparison value
1 Pulse on reaching the comparison value
Operating Instructions, 02/2007, A5E00124867-05
Designation
STS_ND
STS_UFLW
STS_OFLW
STS_SYN
Technological Functions