Siemens SIMATIC ET 200S Operating Instructions Manual page 120

1Count5V/500kHz
3.3 Example: Start 1Count5V/500kHz
Configuring with STEP 7 using HW Config
You must first adapt the hardware configuration of your existing ET 200S station.
1. Open the relevant project in SIMATIC Manager.
2. Open the HW Config configuration table in your project.
3. Select the 1Count5V/500kHz Counting Mode from the hardware catalog. The number
4. Drag the entry to the slot at which you have installed your 1Count5V/500kHz.
5. Double-click this number to open the 1Count5V/500kHz C (R-S Slot Number) tab.
6. Save and compile your configuration, and download the configuration in STOP mode of
120
6ES7 138-4DE02-0AB0 C appears in the infotext.
On the Addresses tab, you will find the addresses of the slot to which you have dragged
the 1Count5V/500kHz. Make a note of these addresses for subsequent programming.
On the Parameters tab you will find the default settings for the 1Count5V/500kHz. Leave
the default settings unchanged.
the CPU by choosing "PLC > Download to Module".
Technological Functions
Operating Instructions, 02/2007, A5E00124867-05