3.3
Example: Start 1Count5V/500kHz
Task
These instructions guide you to a functioning application that will enable you to count the
pulses of an encoder and become familiar with and check the basic hardware and software
functions of your 1Count5V/500kHz. The counting mode used in this example is "Count
continuously".
Requirements
The following requirements must be satisfied:
• You have commissioned an ET 200S station on an S7 station with a master.
• You must have the following:
Installation, Wiring and Fitting
1. Install and wire the TM-E30S44-01 terminal module (see Figure).
2. Connect the 1Count5V/500kHz to the terminal module (you will find detailed instructions
Figure 3-1
Technological Functions
Operating Instructions, 02/2007, A5E00124867-05
– A TM-E30S44-01 terminal module
– A 1Count5V/500kHz
– A 5 V encoder with a 24 V encoder supply and the material required for wiring
on how to do this in the
Terminal Assignment for the Example
ET 200S Distributed I/O System
1Count5V/500kHz
3.3 Example: Start 1Count5V/500kHz
Manual).
119