Siemens SIMATIC ET 200S Operating Instructions Manual page 181

Function of the Digital Output DO1
For the "Function DO1" parameter, select one of the following functions for the digital output:
• Output (no switching by the limit-value monitoring)
• Measured value outside the limits
• Measured value under the low limit
• Measured value over the high limit
Function of the Digital Output DO2
• Output
Changing Values during Operation
The following values can be changed during operation:
• Low limit (LOAD_PREPARE)
• High limit (LOAD_VAL)
• Function of the digital output DO1 (C_DOPARAM)
• Integration time/update time (C_INTTIME)
See also
Gate Functions in Measurement Modes (Page 182)
Behavior of the Outputs in Measurement Modes (Page 183)
Assignment of the Feedback and Control Interfaces for the Measurement Modes (Page 185)
Technological Functions
Operating Instructions, 02/2007, A5E00124867-05
1Count5V/500kHz
3.7 Measurement Modes
181