4.3
Example: Starting 1SSI
Introduction
These instructions provide an example to guide you to a functioning application that will
enable you to become familiar with and check the basic hardware and software functions of
the 1SSI. For this example, you will operate the 1SSI in standard mode, rather than
isochrone mode.
Requirements
The following requirements must be satisfied:
• You have commissioned an ET 200S station on an S7 station with a master.
• You must have the following:
Installation, Wiring and Fitting
1. Install and wire the TM-E15S24-01 terminal module (see Figure).
2. Connect the 1SSI to the terminal module (you will find detailed instructions in the
Figure 4-1
Technological Functions
Operating Instructions, 02/2007, A5E00124867-05
– A TM-E15S24-01 terminal module
– An 1SSI
– An SSI encoder and the necessary wiring material
ET 200S Distributed I/O System
Terminal Assignment for the Example
Manual).
1SSI
4.3 Example: Starting 1SSI
223