Siemens SIMATIC ET 200S Operating Instructions Manual page 311

General Technical Specifications
Data for the Digital Outputs
Output voltage
•
Output current
•
•
Minimum pulse duration
Accuracy
Output delay (with resistive load)
•
•
Lamp load
Control of a digital input
Switching frequency
•
•
•
Limitation (internal) of the inductive circuit
interruption voltage
Short-circuit protection for output
•
Cable lengths
•
•
Status, Interrupts, Diagnostics
Status indicators
Diagnostic functions
•
•
Update rate for feedback messages
Polarity reversal can lead to the digital outputs being switched through.
1
See the figures below
2
With a load of ≤ 50 Ω
3
Technological Functions
Operating Instructions, 02/2007, A5E00124867-05
With signal "1"
With signal "1"
Rated value
–
Permitted Range
–
With signal "0" (leakage current)
At "0" to "1"
At "1" to "0"
With resistive load
With inductive load
With lamp load
Response threshold
Unshielded
Shielded
Group error
Diagnostic information readable
5.5 Technical Specifications of the 2PULSE, Terminal Assignment
Minimum L+ - 1 V
2 A
7 mA...2 A
max. 0.5 mA
200 µs
± (pulse duration x 100 ppm) ±100 µs
max. 100 µs
max. 200 µs
Maximum 10 W
Yes
2.5 kHz
≤2 Hz
≤10 Hz
L+ -(50 V ... 65 V)
Yes
Typically 10 A
600 m
1000 m
Green LED for DI 0, DI 1, DO 0, DO 1
Red LED "SF"
Yes
1.2 ms
2)
2PULSE
3)
311