Table 2-5 Notes On The Control Bits - Siemens SIMATIC ET 200S Operating Instructions Manual

1Count24V/100kHz
2.6 Count Modes
Address
Byte 5
C_DOPARAM
CMP_VAL2
CMP_VAL1
LOAD_PREPARE
LOAD_VAL
Bytes 6 to 7
Not used for modified user interface
1
Notes on the Control Bits
Table 2-5 Notes on the Control Bits
Control bits Notes
C_DOPARAM Change function and behavior of DO1, DO2 (see figure below)
The values from bytes 0 to 2 are applied as new function, hysteresis, and pulse duration of DO1,
DO2. This may result in the following error: The conditions for the "Switch at comparison values"
behavior are not fulfilled.
CMP_VAL1 Load comparison value 1 (see figure below)
The value from bytes 0 to 3 is transferred to comparison value 1 with the control bit "Load
comparison value CMP_VAL1".
CMP_VAL2 Load comparison value 2 (see figure below)
The value from bytes 0 to 3 is transferred to comparison value 2 with the control bit "Load
comparison value CMP_VAL2".
CTRL_DO1 Enable DO1
You use this bit to enable the DO1 output.
CTRL_DO2 Enable DO2
You use this bit to enable the DO2 output.
CTRL_SYN You use this bit to enable synchronization.
EXTF_ACK Error acknowledgment
The error bits must be acknowledged with the EXTF_ACK control bit after the cause is removed. (see
figure below)
LOAD_PREPARE Load counter preparatory (see figure below)
The value from bytes 0 to 3 is applied as the load value.
LOAD_VAL The value from bytes 0 to 3 is loaded directly as the new counter value (see figure below).
RES_STS Start resetting of status bit
The status bits are reset through the acknowledgment process between the RES_STS bit and the
RES_STS_A bit. (see figure below)
SET_DO1 Control bit DO1
Switches the DO1 digital output on and off when CTRL_DO1 is set.
SET_DO2 Control bit DO2
Switches the DO2 digital output on and off when CTRL_DO2 is set.
SW_GATE SW gate control bit
The SW gate is opened/closed via the control interface with the SW_GATE bit.
48
Assignment
Bit 7: Reserve = 0
Bit 6: Reserve = 0
Bit 5: Reserve = 0
Bit 4: Change function and behavior of DO1, DO2
Bit 3: Load comparison value 2
Bit 2: Load comparison value 1
Bit 1: Load counter preparatory
Bit 0: Load counter direct
Reserve = 0
1
Technological Functions
Operating Instructions, 02/2007, A5E00124867-05