Control Interface (Piq) And Feedback Interface (Pii); Basics Of Control Interface (Piq) And Feedback Interface (Pii) - Siemens Simantic ET 200S Manual

4 IQ-SENSE (6ES7138-4GA00-0AB0)

5.3 Control interface (PIQ) and feedback interface (PII)

5.3 Control interface (PIQ) and feedback interface (PII)
5.3
5.3.1

Basics of control interface (PIQ) and feedback interface (PII)

Introduction
You can configure the address space of the control and feedback interfaces of the
4 IQ-SENSE. You can choose between Standard and Enhanced.
Standard features
• The 4 IQ-SENSE occupies 4 bits in the feedback interface.
• You can evaluate the circuit state of each channel using the feedback interface.
Enhanced features
• The 4 IQ-SENSE occupies one byte in the control interface and one in the feedback
• You can use the control interface to specify the sensitivity and distance values for each
• You can use the feedback interface to evaluate the acquired sensitivity and distance
Requirements:
• You can use the "IQ-SENSE Opto" function block. The FB facilitates easy access to the
• Please note that in this case PII equals PIQ.
• You can download the function block and the relevant product information on the Internet
Configuring the address space
Address area
Standard
Enhanced
5-8
interface.
IntelliTeach
channel ( via "IQ-SENSE Opto" FB) and execute
values (switching threshold) and the circuit state for each channel.
control and feedback interface.
at http://www.ad.siemens.de/csi_e/gsd.
With STEP 7 as of V5.1, Service
In the hardware catalog of HW
Config, choose 4 IQ-SENSE Opto
S
In the hardware catalog of HW
Config, choose 4 IQ-SENSE Opto
E
Pack 3
From the GSD file, choose S
6ES7138-4GA00-0AB0 IQ-SENSE Opto
From the GSD file, choose E
6ES7138-4GA00-0AB0 IQ-SENSE Opto
Teach-in
.
With STEP 7 as of V4.02 or
COM PROFIBUS or other configuration
software
Manual, Edition 10/2005, A5E00514527-01
ET 200S