Table 5-1 Parameter List For The Filling Process - Siemens SIMATIC ET 200S Operating Instructions Manual

Parameters
The following parameters are required for channel 0 of the 2PULSE to fill liquids in pulse
output mode.
Table 5-1 Parameter List for the Filling Process
Parameters
Group diagnosis
Diagnostics DO 0
Behavior at CPU-Master-STOP
Mode
Time base
DI function 0
On-delay
The additional parameters of channel 0 of the 2PULSE have no effect on the pulse output
mode.
The parameters for channel 1 are not relevant in this application example.
Technological Functions
Operating Instructions, 02/2007, A5E00124867-05
Set Value
Enable
On
Turn off DO1
Pulse output
1 ms
Input
0
5.4 Application Examples
Meaning
The following errors trigger a diagnostic
message:
Short circuit - DO digital output
•
Short circuit of the sensor supply
•
Parameter Assignment Error
•
The 2PULSE detects the short circuit error at
the DO 0 digital output.
All the preset times are specified at a
resolution of 1 ms.
The digital input is used to establish whether
the container is correctly positioned.
The valve is opened immediately with
SW_ENABLE = 1
2PULSE
293