Assignment Of The Feedback And Control Interface For Position Feedback; Table 2-24 Feedback Interface (Inputs) - Siemens SIMATIC ET 200S Operating Instructions Manual

2.8.6

Assignment of the Feedback and Control Interface for Position Feedback

Note
The following data of the control and feedback interfaces are consistent for the
1Count24V/100kHz:
Bytes 0 to 3
Bytes 4 to 7
Bytes 8 to 11 (modified user data interface)
Use the access or addressing mode for data consistency over the entire control and
feedback interface on your master (only for configuration using the GSD file).
Assignment Tables
Table 2-24 Feedback Interface (Inputs)
Address Assignment
Bytes 0 to 3 Count value or stored count value in the case of the latch function on the digital
input
Byte 4 Bit 7:
Bit 6:
Bit 5:
Bit 4:
Bit 3:
Bit 2:
Bit 1:
Bit 0:
Byte 5 Bit 7:
Bit 6:
Bit 5:
Bit 4:
Bit 3:
Bit 2:
Bit 1:
Bit 0:
Technological Functions
Operating Instructions, 02/2007, A5E00124867-05
Short circuit of the encoder supply
Reserve = 0
Parameter assignment error
Reserve = 0
Reserve = 0
Resetting of status bits active
Load function error
Load function is running
Down direction status
Up direction status
Reserve = 0
Reserve = 0
Reserve = 0
Reserve = 0
DI status
Internal gate status
1Count24V/100kHz
2.8 Position Detection
Designation
ERR_24V
ERR_PARA
RES_STS_A
ERR_LOAD
STS_LOAD
STS_C_DN
STS_C_UP
STS_DI
STS_GATE
97