Home >
Scan
>
Scan Using the Scan Button on Your Brother Machine
a PDF File
Save Scanned Data to a Folder as a PDF File
Scan documents and save them to a folder on your computer as PDF files.
Use the Scan button on the machine to make temporary changes to the scan settings. To make permanent
changes, use either ControlCenter4 (Windows
>> DCP-T310/DCP-T510W/DCP-T710W/MFC-T810W
>> MFC-T910DW
DCP-T310/DCP-T510W/DCP-T710W/MFC-T810W
1. Load your document.
2. Press
(SCAN).
3. Press a or b to select the [Scan to PC] option, and then press OK.
4. Press a or b to select the [File] option, and then press OK.
5. If the machine is connected over the network, press a or b to select the computer where you want to send
data, and then press OK.
If the LCD prompts you to enter a PIN, use the control panel to enter the four-digit PIN for the computer,
and then press OK.
6. Do one of the following:
•
To change the settings, press Options or Copy / Scan Options, and then go to the next step.
•
To use the default settings, press Mono Start or Colour Start.
-
[Scan Type] depends on the default settings. Pressing Mono Start or Colour Start does not allow
you to change the settings.
-
To use scan options, a computer with either ControlCenter4 (Windows®) or Brother iPrint&Scan (Mac)
software installed must be connected to the machine.
7. The machine will prompt you to set each of the following scan settings. Press a or b to select the desired
option, and then press OK to proceed to the next scan setting.
•
[Scan Type]
•
[Resolution]
•
[File Type]
•
[Document Size]
•
[Remove Bkg Clr]
8. Press Mono Start or Colour Start.
®
) or Brother iPrint&Scan (Mac) software.
> Save Scanned Data to a Folder as
107