Ink Absorber Full - Brother DCP-T310 User Manual

Error Message
Connection Error
Connection Failed
Cover is Open.
Data Remaining
Disconnected
Document Jam
DR Mode in Use
High Temperature
Hub is Unusable.

Ink Absorber Full

Cause
Other devices are trying to connect to the
Wi-Fi Direct network at the same time.
The Brother machine and your mobile
device cannot communicate during the
Wi-Fi Direct network configuration.
The scanner cover is not locked in the
closed position.
The ink tank cover is not locked in the
closed position.
Print data is left in the machine's memory. Press Stop/Exit. The machine will cancel
The other person or other person's fax
machine stopped the call.
The document was not inserted or fed
correctly, or the document scanned from
the ADF was too long.
The machine is in Distinctive Ring mode.
You cannot change the Receive Mode
from Manual to another mode.
The room temperature is too high.
A hub or USB flash drive with hub has
been connected to the USB direct
interface.
The ink absorber box is full. These
components are periodic maintenance
items that may require replacement after
a period of time to ensure optimum
performance from your Brother machine.
Because these components are periodic
maintenance items, the replacement is
not covered under the warranty. The need
Action
Make sure there are no other devices
trying to connect to the Wi-Fi Direct
network, and then try to configure the Wi-
Fi Direct settings again.
• Move the mobile device closer to your
Brother machine.
• Move your Brother machine and the
mobile device to an obstruction-free
area.
• If you are using the PIN Method of
WPS, make sure you have entered the
correct PIN.
Lift the scanner cover and then close it
again.
Make sure the interface cable (if used)
have been guided correctly through the
cable channel and out the back of the
machine.
Firmly close the ink tank cover until it
locks into place.
the job and clear it from the memory. Try
to print again.
Try to send or receive again.
If calls are stopped repeatedly and you
are using a VoIP (Voice over IP) system,
try changing the Compatibility to Basic (for
VoIP).
See Related Information: Telephone Line
Interference/VoIP.
Remove the jammed document, and then
press Stop/Exit. Set the document in the
ADF correctly.
See Related Information: Load
Documents in the Automatic Document
Feeder (ADF).
See Related Information: Document
Jams.
Set Distinctive Ring to Off.
See Related Information: Turn off
Distinctive Ring.
After cooling the room, allow the machine
to cool down to room temperature. Try
again when the machine has cooled
down.
Hubs, including a USB flash drive with a
built-in hub, are not supported. Unplug the
device from the USB direct interface.
The ink absorber box must be replaced.
Contact Brother customer service or your
local Brother Authorised Service Centre to
have your machine serviced.
399