Paper Size Mismatch - Brother DCP-T310 User Manual

Error Message
No Paper Fed
No Paper Fed Again
No Response/Busy
Not Registered
Out of Fax Memory
Out of Memory

Paper Size Mismatch

Cause
The machine is out of paper or paper is
not correctly loaded in the paper tray.
The paper was not inserted in the centre
position of the manual feed slot.
The Jam Clear Cover is not closed
correctly.
Paper dust has accumulated on the
surface of the paper pick-up rollers.
Paper dust has accumulated on the
surface of the paper pick-up rollers.
The number you dialled does not answer
or is busy.
You tried to access a Speed Dial number
that has not been stored in the machine.
The fax memory is full.
The machine's memory is full.
The paper size setting does not match the
size of paper in the tray.
-OR-
You did not set the paper guides in the
tray to the indicators for the paper size
you are using.
Action
Do one of the following:
• Refill the paper tray, and then press c.
• Remove and reload the paper, and
then press c.
See Related Information: Load Paper.
Remove the paper and reinsert it in the
centre of the manual feed slot, and then
follow the LCD instructions.
See Related Information: Load Paper in
the Manual Feed Slot.
Make sure the Jam Clear Cover is closed
evenly at both ends.
See Related Information: Printer Jam or
Paper Jam.
Clean the paper pick-up rollers.
See Related Information: Clean the Paper
Pick-up Rollers.
Clean the paper pick-up rollers.
See Related Information: Clean the Paper
Pick-up Rollers.
Verify the number and try again.
Set up the Speed Dial number.
Print the faxes that are in the memory.
See Related Information: Print a Fax
Stored in the Machine's Memory.
If a fax-sending or copy operation is in
progress:
• Press Stop/Exit and wait until the
other operations that are in progress
finish, and then try again.
• Press c to select Partial Print to
copy the pages scanned so far.
• Print the faxes that are in the memory.
See Related Information: Print a Fax
Stored in the Machine's Memory.
1. Check that the paper size you chose
on the machine's display matches the
size of the paper in the tray.
See Related Information: Change the
Paper Size and Paper Type.
2. Make sure you loaded the paper in a
Portrait position, by setting the paper
guides at the indicators for your paper
size.
See Related Information: Load Paper.
3. After you have checked the paper size
and the paper position, press c.
If you are printing from your computer,
make sure the paper size you chose in
the printer driver matches the size of
paper in the tray.
402