Brother DCP-T310 User Manual page 407

Error Message
Jam D MP Tray
Jam E Inside/MP
Repeat Jam E In/MP
Low Temperature
Media card error
Media is Full.
No Caller ID
No Device
No File
Cause
Paper dust has accumulated on the
surface of the paper pick-up rollers.
The paper is jammed in the machine.
The paper guides are not set to the
correct paper size.
The paper is jammed in the machine.
The paper guides are not set to the
correct paper size.
The room temperature is too low.
Multiple data storage devices were in the
machine when it was turned on. The
machine can read only one memory card
or USB flash drive at a time.
The USB flash drive you are using already
contains 999 files.
The USB flash drive you are using does
not have enough free space to scan the
document.
There is no incoming call history. You did
not receive calls or you have not
subscribed to the Caller ID service from
your telephone company.
When configuring the Wi-Fi Direct
network, the Brother machine cannot find
your mobile device.
The memory card or USB flash drive in
the media drive does not contain a .JPG
file.
Action
DO NOT extend the paper tray when you
load A5 or smaller size paper. (for some
countries)
Clean the paper pick-up rollers.
See Related Information: Clean the Paper
Pick-up Rollers.
Remove the jammed paper.
See Related Information: Paper is
Jammed in the Multi-purpose Tray (Jam D
MP tray).
Make sure the paper guides are set to the
correct paper size.
Remove the jammed paper.
See Related Information: Paper is
Jammed Inside and in the Multi-purpose
Tray (Jam E Inside/MP).
Make sure the paper guides are set to the
correct paper size.
After warming the room, allow the
machine to warm up to room temperature.
Try again when the machine has warmed
up.
Remove the memory card(s) or USB flash
drive that you are not using.
Your machine can only save to your USB
flash drive if it contains fewer than 999
files. Delete unused files and try again.
Delete unused files from your USB flash
drive to make some free space, and then
try again.
To use the Caller ID feature, contact your
telephone company.
See Related Information: Caller ID.
• Make sure your machine and mobile
device are in the Wi-Fi Direct mode.
• Move the mobile device closer to your
Brother machine.
• Move your Brother machine and the
mobile device to an obstruction-free
area.
• If you are manually configuring the Wi-
Fi Direct network, make sure you have
entered the correct password.
• If your mobile device has a
configuration page for how to obtain
an IP address, make sure the IP
address of your mobile device has
been configured via DHCP.
Put the correct memory card or USB flash
drive into the slot again.
401