Brother DCP-T310 User Manual page 317

b. Select [WLAN]. Press OK.
c. Select [WPS w/PIN Code]. Press OK.
3. When [WLAN Enable?] appears, press a to select [Yes].
This will start the wireless setup wizard. To cancel, press Stop/Exit.
4. The LCD displays an eight-digit PIN and the machine starts searching for a wireless LAN access point/router.
5. Using a computer connected to the network, in your browser's address bar, type the IP address of the device
you are using as the Registrar. (For example: http://192.168.1.2)
6. Go to the WPS settings page and type the PIN, and then follow the on-screen instructions.
• The Registrar is usually the wireless LAN access point/router.
• The settings page will differ depending on the brand of wireless LAN access point/router. For more
information, see the instructions supplied with your wireless LAN access point/router.
If you are using a Windows
following steps:
7. Do one of the following:
®
• Windows 7
Click (Start) > Devices and Printers > Add a device.
®
• Windows 8
Move your mouse to the lower right corner of your desktop. When the menu bar appears, click Settings >
Control Panel > Hardware and Sound > Devices and Printers > Add a device.
®
• Windows 10
Click > Windows System > Control Panel. In the Hardware and Sound group, click Add a device.
• To use a Windows
your network in advance. For more information, see the instructions supplied with your wireless LAN
access point/router.
• If you use Windows
after the wireless configuration by following the on-screen instructions. To install the Full Driver &
Software Package necessary for operating your machine, insert the Brother installation disc into your
computer or go to your model's Downloads page on the Brother Solutions Center at
support.brother.com.
8. Select your machine and click Next.
9. Type the PIN displayed on the machine's LCD, and then click Next.
®
10. (Windows 7) Select your network, and then click Next.
11. Click Close.
MFC-T910DW
1. Press Settings.
2. Press a or b to select the following:
a. Select [Network]. Press OK.
b. Select [WLAN]. Press OK.
c. Select [WPS w/PIN Code]. Press OK.
3. When [Enable WLAN?] appears, press c.
The wireless setup wizard starts. To cancel, press d.
4. The LCD displays an eight-digit PIN and the machine starts searching for a wireless LAN access point/router.
5. Using a computer connected to the network, in your browser's address bar, type the IP address of the device
you are using as the Registrar. (For example: http://192.168.1.2)
® ®
7, Windows 8, or Windows
® ®
7, Windows 8, or Windows
® ®
7, Windows 8, or Windows
®
10 computer as a Registrar, complete the
®
10 computer as a Registrar, you must register it to
®
10 as a Registrar, you can install the printer driver
311