Brother DCP-T310 User Manual page 33

Home > Paper Handling
Tray
Load Photo Paper in the Paper Tray
• If the [Check Paper] setting is set to [On] and you pull the paper tray out of the machine, a message
appears on the LCD asking if you want to change the paper type and paper size. Change the Paper Size
and Paper Type settings if needed, following the LCD instructions.
• Load only one size and type of paper in the paper tray at a time.
• When you load a different paper size in the tray, you must change the Paper Size setting in the machine or
the paper size setting on your computer.
Doing this enables the machine to automatically feed paper from the appropriate tray if Auto Tray Select
has been set in the machine or printer driver. (MFC-T910DW)
1. If the paper support flap (1) is open, close it, and then close the paper support (2).
2. Pull the paper tray completely out of the machine.
3. Open the output paper tray cover (1).
1
4. Gently press and slide the paper width guides (1) to fit the paper size, and then lift up the stopper (2).
> Load Paper > Load Paper in the Paper Tray
1
2
> Load Photo Paper in the Paper
27