Brother DCP-T310 User Manual page 429

IMPORTANT
• DO NOT touch the encoder strip, a thin strip of plastic that stretches across the width of the machine
(1). Doing this may cause damage to the machine.
1
• If the print head is in the right corner as shown in the illustration (2), you cannot move it. Follow these
steps:
a. Close the scanner cover, and then reconnect the power cord.
b. Open the scanner cover again, and then hold down the Stop/Exit button until the print head
moves to the centre.
c. Unplug the machine from the power source and remove the jammed paper.
• If the paper is jammed under the print head, unplug the machine from the power source, and then
move the print head to take out the paper.
Hold the concave areas with the triangle marks as shown in the illustration (3) to move the print head.
1
2
3
423