3Com NBX 100 Installation Manual page 133

Never use a telephone that is near the source of a gas leak to report
I
the leak.
The NBX 100 chassis is equipped with a three-prong grounding plug.
I
Do not defeat the protection offered by the plug by clipping the
grounding prong or using an adapter to connect the system to a
two-wire power source.
Do not staple the power cord or otherwise attach the power cord to
I
building surfaces.
Do not use an AC power converter on a telephone or DSS/BLF adjunct
I
other than the one that is shipped with the device.
Power Cord Set:
I
For European countries, see Table 16. If your country is not listed
specifically, use the power cord set information for Europe. For
countries outside of Europe, you must use a power cord set that
complies with the relevant national standards for cable type and
appliance coupling.
Table 16 Regulatory Requirements
Country Power Cord Set Details
Europe
I
I
United Kingdom
I
I
Italy
I
I
Denmark
I
Switzerland
I
The appliance coupler (that is, the connector to the unit, not the
I
connector to the wall plug) must have a configuration that mates with
an EN60320/IEC320 appliance inlet.
The socket outlet must be near the unit and easily accessible. You can
I
remove power from the unit only by disconnecting the power cord
from the outlet.
The supply plug must comply with CEE 7/7 ("SCHUKO")
The mains cord must be <HAR> or <BASEC> marked and be
of type HO3VVF3GO.75 (minimum).
The supply plug must comply with BS1363 (3-pin 13 A) and
be fitted with a 5A fuse that complies with BS1362.
The mains cord must be <HAR> or <BASEC> marked and be
of type HO3VVF3GO.75 (minimum).
The supply plug must comply with CEI23-16/VII.
The mains cord must be <HAR> or <BASEC> marked and be
of type HO3VVF3GO.75 (minimum).
The supply plug must comply with section 107-2-D1,
standard DK2-1a or DK2-5a.
The supply plug must comply with SEV/ASE 1011.
Important Safety Information 133