Pop3 Communication Timeout Setting; Reception Check Interval Setting - Sharp MX-B355W User Manual

SYSTEM SETTINGS►SYSTEM SETTINGS
Receiving Date & Time Print
Enable this setting to have the date and time of reception printed.
Select [Inside the Received Image] or [Outside the Received Image] for the position where the date and time is printed.
When [Inside the Received Image] is selected, the date and time of reception is printed on the received image.
When [Outside the Received Image] is selected, the received image is reduced and the date and time of reception is
printed in the blank area that results.
The [Outside the Received Image] cannot be selected for the reception date and time print setting if
Setting (page 7-104)" is not enabled.

POP3 Communication Timeout Setting

The duration of time the machine waits until stopping reception can be set from 30 to 300 seconds in increments of 30
seconds if no response is received from the mail server (POP3 server).

Reception Check Interval Setting

Specifies an interval at which the machine automatically checks the mail server (POP3 server) for received Internet
faxes. The interval can be set from 0 minutes to 8 hours in increments of 1 minute.
If 0 hours 0 minutes is specified, the machine does not automatically check the mail server for received Internet faxes.
The machine also checks the mail server (POP3 server) for received Internet faxes when the main power is switched on.
(Except when 0 hours 0 minutes is specified.)
Received Data Print Size Settings
Set 8-1/2" x 11" (A4) size as the paper size that is always used for printing of received Internet faxes.
Allow/Reject Mail or Domain Name Setting
Allows or refuses a reception from specified addresses/domains.
Item
Item
Allow Reception
All Invalid
Add New
Registered address or domain list
When there are no stored anti junk mail addresses or domains, only the [Add New] key can be selected.
Reception from the stored address/domain is not allowed.
Reception from the stored address/domain is allowed.
All Invalid
Adds a new address or domain (maximum of 50) from which reception is to be rejected or
allowed.
Enter the address/domain (maximum of 64 characters) and tap the [Store] key.
If the first character of the entry is not "@", the entry is identified as an address. If the first
character is "@", the entry is identified as a domain. (xxx@xx.xxx.□□□ is treated as an
address, and @xx.xxx.□□□ is treated as a domain. ) Storing an address specifies only that
address. Storing a domain specifies all addresses that include that domain.
Displays a list of the stored addresses and domains. An address or domain can be deleted
from the list when selected.
7-105
"Auto Receive Reduce
Settings